Install wxgtk centos

Become superuser: su Your root password is required here. Install wxGTK: make install Link the library: ldconfig Exit from superuser mode: exit Normally, wxGTK is installed but there might be a problem with wxPython: it is possible that the library is not installed where wxPython is looking for it. In a mandrake 7. Install the module: python setup. Make sure you have recent versions of pip and setuptools installed.

Instead binary wheels are made available for a few popular linux distributions, and you can install them using pip once you locate the proper folder to tell pip to download from.

Asked 11 years, 7 months ago. Active 11 years, 7 months ago. Viewed 1k times. Improve this question. Add a comment. Active Oldest Votes. You added the repository for EL4. CentOS 5 is EL5. Improve this answer. I copied the wrong lines from Installing RPMforge article. Thank you so much. I cant post comments yet. I hope this can help.

Rashad A. I first got rid of the uber-new "libwxgtk I installed them one by one some of them had unresolved dependencies but never mind. Here's the list of rpms: wxBase Then, I again launched make without the "-j" from within wxWidgets This time the "make" exited well.

I followed your suggestions and did this: Code: Select all su make install ldconfig. Code: Select all The installation of wxWidgets is finished. On certain platforms e. Read the wxWindows Licence on licencing conditions. I managed to build and install maitreya. It took some time though. I build and installed maitreya8 from source after installing wxWidgets formerly called wxWindows. Only after wx-config is properly installed and responsive one can proceed with 3rd party software. Still after installing it, the software SW wasn't starting up, a menu entry appeared but was not responsive to mouse-click.